linerscript.blogg.se - P5 led panels outdoor

#P5 led panels outdoor how to
#P5 led panels outdoor install
#P5 led panels outdoor full
#P5 led panels outdoor series

Is standing for Pixel Pitch, or dot pitch, the number is saying that the accurate distance measuring in millimeters.Īctually, pixel pitch indicates the space from the center of a pixel to the center of the adjacent pixel, the larger pixel pitch means there is more space between pixels, determine Just like the most important factor in relation with LED display resolution, we define a module as P2, P2.5, P3, etc, which is consisting of the letter 'P' and a number affixed next, this letter here What is the "Pixel Pitch"(P2 P3 P4 P5) in LED Display Screen and How Many LEDs Per Square Meter High Brightness LCD Display for Store Window.All-in-one Conference LED Display System.

#P5 led panels outdoor series

Lightweight HKN Series Outdoor LED Display.Small Pixel Pitch LED Modules (P1.25-P2).Decorative LED Light Strings & Lanterns.If the matrix is still out of range, set the DCLK as low as possible and adjust the refresh rate until you are able to get the panel in range.That should make your matrix come in range if it was out.

Check your cabinet setting, if anything is in red, adjust the multiple down from refresh x16 to refresh x8.

On the main screen, the module size at the top should now read 64x16.After that, click the first square on line 10, then 11, 12, 13, 14, 15, and 16. Start on line nine column one and drag your cursor across until the end. On the final page, you should have a screen that is 64 cells wide by 16 cells tall.On Guide 6, set the number to two, press next.On Guide 5, set the number to 16, press next.When you get to guide 4, switch the colors, if needed, and press next.Fill in the width as 64, press next, and next your way to guide 4 (in the title bar).Click "Intelligent Setting" at the bottom.If your width and height on the main screen were out of range before, set it properly now even if it is out of range.Click on "Modify" to make the width and height 64x32, click the X next to the sideways pin above.If it is out of range, fudge the numbers so they are in range, we will fix it later. Set your width and height in the two white boxes to your matrix size in pixels.

Set the "Data Group" to "Normal 32 Groups".

#P5 led panels outdoor full

On the center tab (Receiver Parameters), click Load > Preset Parameters > General Parameters Full Color > 14 full color eight scan.

Press "Save to Devices" at the bottom of the screen.

Make sure the grey box updates with those numbers. The col and row boxes should both be set to 1.

On the third tab (Receiver Mapping), click on the box in the grey area and set the width and height of your matrix in pixels.

If you get something in the window below, great, if not, you need to troubleshoot this before moving on.

Select your network card and press "Detect Receiver Cards.".

On the first tab (Sending Device), make sure the middle option labeled "Net Card" is selected.

Click Control > LED Screen Settings (password 168).

This setting has no major purpose for setup. The x and y parameters correspond to the the location of the virtual display on your computer screen.

Click Control > Screen Size and Count Settings.

#P5 led panels outdoor install

Download and install LEDvision 8.5 or higher, not 5.0 and not 6.8 or 6.9.

Plug your Colorlight card directly into your Gigabit NIC without anything in between such as a switch.

#P5 led panels outdoor how to

This is a step by step guide that will show you how to configure a Colorlight card to control a set of Wired Watts Outdoor P5 panels.